diff --git a/docs/workshops/Workshop_1_FabulaserMini.md b/docs/workshops/Workshop_1_FabulaserMini.md
index 181043241c61a338352d5192b46dbb8f8ba46660..8093471949e6344c6258076805aa02fe4eab0faa 100644
--- a/docs/workshops/Workshop_1_FabulaserMini.md
+++ b/docs/workshops/Workshop_1_FabulaserMini.md
@@ -99,7 +99,7 @@ Following is the workshop agenda with approx times:
 
   - (9:20-9:30 - Room setup, only organizers)
   - 9:30-9:40 - Gathering time 
-  - 9:40-9:50 - Introduction about laserable materials
+  - 9:40-9:50 - Introduction about CO2 laserable materials
   - 9:20-9:25 - Machine parts and tools organization
   - 9:25-9:30 - Daily group division
   - 9:30-12:00 - Hands-on assembly work
@@ -203,6 +203,37 @@ If you would like to test the machine, please download and install the following
 ## Report
 
 #### Day 1
+
+The first day of the workshop went through the planned schedule. In the morning the timing was pretty good, but a very long lunch break (because the absence of a close place where to eat). 
+
+Given the large size of the room, more than 100m2, we had quite lot of space to separate the 2 machine kits, tools and groups of people.
+
+The organization was the following:
+
+- 2 machines kits were available, kit3 and kit4
+- given the 10 participants we decided to build 2 machines simultaneously
+- the two groups were split in two separated room areas to avoid mixing of parts and of tools
+- to each group the following was given:
+  - a dedicated set of tools
+  - a complete kit of machine parts (except chiller, radial fan and air filter)
+- the 2 groups were divided in 2 subgorups, to allow parallel building of different machine parts
+
+Building time was at normal speed, careful alignment of everything.
+
+We ended at the following stage:
+
+- assembled and attached Y axis
+- assembled bed
+- assembled X axis
+- assembled and wired electronics
+
+During the day we had the following issues:
+
+- we found some manual lack of labels or information
+- the separator panel was milled with wrong size (because of a shift of the piece during milling)
+ - solution: to cut of the additional size from the top with a cuting knife and to enlarge the holes
+- one of the pulleys of the kit 3 is wobbling
+
 #### Day 2
 #### Day 3
 #### Day 4
@@ -212,7 +243,6 @@ If you would like to test the machine, please download and install the following
 
 ### Final results
 
-### Issues and lesson learned
 
 ### Thanks