Step by Step Assembly.md

Build Instructions

The build instructions below are divided into two parts, namely pre-assembly and final assembly. In the pre-assembly some of the sub-assmeblies or parts are either prepared or assembled together to ease the final assembly. The numbering system below will be referred to within the build manual by appending each number after the previous number for eg. the LM12UU bearing installation is in step 1.4.1 and can be looked up in the list below as part of the Build Platform assembly > Z-Axis Bearing Holder > LM12UU Bearing. The number in the (#) paranthesis denotes the quantity of the part.

Pre-Assembly

1. Frame Pre-assembly

Parts required:

1. Left Side Frame (1)
   1. 500mm 3030 profile (2)
   2. 340mm 3030 profile (3)
   3. L bracket (6) with (2) set screws each
2. Right Side Frame (1)
   1. 500mm 3030 profile (2)
   2. 340mm 3030 profile (3)
   3. L bracket (6) with (2) set screws each

2. Y-axis Left Pre-assembly (1)

Parts required:

1. XY Idler Assembly Left (1)
   1. Printed XY Idler - Left (1)
      1. M3 Nut (2)
      2. M3x20mm bolt (1)
   2. M3x30mm bolt (1)
   3. 3mm Bore GT2 Pulleys (2)
   4. M3 shim washer (4)
2. XY Stepper Motor Assembly Left (1)
   1. Printed Stepper Motor Bracket - Left (1)
      1. M3 Nut (1)
      2. M3x20mm bolt (1)
   2. Nema 17 Motor (1)
   3. GT2 20T Teethed 5 mm Bore Drive Pulley (1)
   4. M3x8mm bolt (1)
   5. M3x10mm bolt (2)
3. 10mm dia 340mm long Smooth Rod (1)
4. LMW10U Bearing (1)

2.1 Subassembly - XY Idler Left